SP108E
Working voltage: DC5-24V
Working current: 25mA-120mA
Control capacity: 2048 pixels
Output signal: SPI signal
Built-in modes: 180 types+ DIY effects
Control mode: APP WiFi control
RGB line sequence: user adjustable in APP
Net weight: 55g
APP: WiFi (LedShop)
Mobile WiFi-APP control
LAN control mode and router control mode
Built-in 180 modes + effect DIY function
Various parameters can be adjusted in the APP
With power failure protection parameter function
SP108E WIFI LED Controller Operating Instructions
1. Features:
1. Long distance APP remote control via WIFI;
2. Support routing mode(AP) and LAN connection mode(STA);
3. Support almost every kind of one-wire or two-wires LED driver IC ;
4. Brightness adjustable, With 180 kinds of patterns and 8 kinds of color adjustable patterns;
5.Creatively using from-image-to-effect method for user to DIY any effect;
6. Support setting pixel number and segments number, able to control up to 2048 pixels;
5. DC5V~24V wide range working voltage, reverse power supply input protection;
6. User setting saving;
App control:
Both IOS version and Android OS version are available. (hardware should support WIFI)
•Requires IOS version 10.0 or later;
•Requires Android OS version 4.4 or later;
•Search”LedShop”in App Store or Google pay or scan this QR code to download and install the App:
Specifications:
Working temperature : -20℃~60℃;
Working Voltage : DC5V~24V;
Working Current : 20mA~130mA;
Remote distance : 30 Meters;
Product size : 85mm*45mm*22mm;
Product weight : 40g ;
Certificates : CE, RoHS;
Working Mode and Connecting:
•AP(Access Point) mode: Controller and Phone connect directly, controller works as an access point.
Connect steps:
1.When the device is not connected to any WIFI network, power on the controller and wait for 20s and then controller will switch into AP mode ;
2.In the WIFI setting page,find and connect the controller(named like SP108E_xxx, the default pin code is 12345678),
3.Open the LED Shop App ,then the controller will be showed on the device list;
•STA(Station) mode: Controller and phone are in one same WIFI network, in this network, users can operate the controller smoothly.
Connect steps:
1.When the device is not connected to any WIFI network,power on the controller,controller will be remain in Wait-For-Connet mode for 20 seconds;
2.Make sure that your phone is connected to a WIFI network, Open LED Shop APP, pressing the Add Device button, input the WIFI pin code, then press the OK to confirm and wait for the configure processing finish;
3.When controller successfully enter the WIFI network, it will be showed on the device list;
4.User can select the controller and remove it out of the network by pressing the Remove Device button,then the controller will switch into AP mode.
Wire Connection：
